Passer au contenu
Supertech 84.5mm Bore Piston Rings - 1x3.10 / 1.2x3.5 / 2.8x3.10mm High Performance Gas Nitrided

Supertech 84.5mm Bore Piston Rings - 1x3.10 / 1.2x3.5 / 2.8x3.10mm High Performance Gas Nitrided

SUPERTECH
Disponibilité:
2 est parti!
UGC R84.5-GNH8450
Économisez 20% Économisez 20%
$28.99
$28.99 - $28.99
$28.99
$23.20
$23.20 - $23.20
$23.20
CALIFORNIA WARNING

Handling passenger or off-highway motor vehicle parts can expose you to chemicals such as phthalates and lead, which can cause cancer and reproductive harm. To minimize exposure, service the vehicle in a well-ventilated area, wear gloves, and wash your hands. For more information see www.P65Warnings.ca.gov/motor-vehicle-parts.

Not CARB legal – cannot ship to CA

Rewards
EARN REWARD POINTS
Purchasing this product will earn you 115 points to redeem on future purchases. Check your points.
Supertech 84.5mm Bore Piston Rings - 1x3.10 / 1.2x3.5 / 2.8x3.10mm High Performance Gas Nitrided

This part also goes by the following cross reference.

Cross Reference Part Number:

About these Piston Rings

The SUPERTECH R84.5-GNH8450 piston rings seal the gap between the piston and the cylinder wall, holding combustion pressure and controlling oil. Worn rings lead to low compression, oil consumption and blow-by.

Frequently asked questions

What do piston rings do?

The top rings seal combustion pressure, and the oil control ring scrapes excess oil from the cylinder wall back into the crankcase. Together they keep compression up and oil out of the combustion chamber.

What are the signs of worn piston rings?

High oil consumption, blue smoke especially under acceleration, low compression or failed leak-down test, loss of power, and excessive crankcase pressure.

What should I check before fitting new rings?

Measure the cylinder bore for wear and taper, and hone or machine it as required so the new rings can seat. Check the ring end gap in the bore and the fit in the piston grooves against specification.

Can I install piston rings myself?

It is a precision job that requires engine disassembly, careful measurement, correct ring orientation and a ring compressor for installation. It is best done by an experienced engine builder.

How do I make sure this piston ring set fits my car?

Compare the part numbers listed on this page with the number on your old part or in your vehicle's parts catalog, and check the fitment information. If you are unsure, contact us with your VIN before ordering.

Euromotiv is an independent retailer of OEM, Genuine, and aftermarket automotive parts. We are not affiliated with, endorsed by, or authorized by Audi AG, Volkswagen AG, BMW AG, Mercedes-Benz Group AG, Dr. Ing. h.c. F. Porsche AG, MINI, or any other vehicle manufacturer. All trademarks, logos, and brand names are the property of their respective owners and are used solely for identification and compatibility purposes.