Air Intake Kit | P-FLO • 3.2L/3.6L VR6

The plastic factory airbox is good at muffling intake noise and enhancing low rpm/low-speed engine performance but becomes very restrictive when the engine is operating in the higher rpm range – where most performance drivers need it. 

The NEUSPEED P-Flo allows you to uncork the intake side of your engine, drawing in a nearly unlimited supply of fresh air.  Plus every P-Flo kit includes a high-performance, oiled multi-layer cotton gauze air filter that is washable and reusable.  You also get a more aggressive, deep throaty engine roar when you step on the gas pedal.

After months of development, NEUSPEED has developed an intake pipe size that matches the factory MAF exactly.  Because of this fuel trims do not affect and will not trigger any DTCs.  In addition, eliminating the OE plastic MAF housing showed an increase in airflow, as no pre-screen is required to reduce turbulence when air is routed through the long piping with its smooth mandrel bends.

Notes

Available in black wrinkle or red wrinkle powder coat pipe option.

As the OE engine cover is an integral part of the OE air intake box, it must be removed as part of the installation of the NEUSPEED P-Flo kit.

CARB EXEMPT: Executive Order # D-236-22

Includes Aluminum heat shield.

The actual parts are shown in the photo.

This part also goes by the following cross reference.

Cross Reference Part Number: