GENUINE PORSCHE

These brake pad damping plates are designed to reduce noise and vibrations while braking.

Are you looking to get your brake calipers back in working order without replacing them altogether? This kit comes with all the necessary items...

Are you sick of not being able to stop in time? New brake pads will restore your stopping power back to the way it was when you first purchased y...

Grinding, pulsating and a lack of stopping power are signs of a bad brake rotor. If your brake pads have worn deep into your rotor, the lip on ...

Grinding, pulsating and a lack of stopping power are signs of a bad brake rotor. If your brake pads have worn deep into your rotor, the lip on ...

Broken, corroded, or frayed cables can all prevent your hand brake from functioning properly. Brand new cables will restore the functionality ...

This special o-ring seals the oil level sending unit to the oil pan. Replace it any time you remove the oil level sender, or if you notice a...

When replacing your valve cover gaskets, it's nice to use fresh, clean hardware when you put everything back together. Clean threads will en...

Over time, the bearings in the rocker arms can wear out, causing them to stick. Replacement is recommended any time you a top-end rebuild.

This tensioner pulley helps maintain proper tension on the accessory drive belt. Grinding or whirring noises coming from the pulley are signs...

Grinding or whirring noises are signs that this part is close to failure. It’s located on the front of the engine between the intermediate sh...

Adjustable lifter.

These o-rings should not be reused, and should be replaced any time the injectors have been removed. Be sure to properly lubricate them on ins...

Over the years and with exposure to extremely hot coolant, the coolant hoses in your vehicle can take a beating. Being made of reinforced rubb...

This third radiator is a feature of the GT3 and Boxster S, as well as cars equipped with Tiptronic transmissions. It provides additional cooling ...

These bolts are a direct fit replacement for your fly wheel and must be replaced after they're removed. One time use only.

This guide tube keeps your throwout bearing centered when actuating the pressure plate. 34mm outer diameter.

This sleeve guides the throwout bearing during clutch operation.

If your clutch cable clevis is bent, rusted, or missing altogether, replace it to restore proper operation of your clutch.

This bearing is located at the rear of the crankshaft in the center of the flywheel.

This trunion is located on the clutch cable, where it meets the clutch release fork. If this piece is missing, your clutch will not operate.

This radial shaft seal prevents leakage at the transmission input shaft, which could cause clutch slippage. It is a good idea to inspect or repla...